AEGN
$24.36
+0.41

Green Rectifier 300W

The Green Rectifier® is Corrpro’s answer to an ecological friendly method of cathodic protection in remote areas where a TEG would normally be utilized. Unlike a TEG which uses a gas to generate a DC voltage, the Green Rectifier® utilizes solar panels and wind generator(s) that are properly sized for the cathodic protection system. The solar panels and wind generator(s) run the CP system as well as having enough power to charge the onboard battery bank. The innovative wind generator(s) allows charging of the system during the day as well as at night (when there is wind). The Green Rectifier® system is designed on a bolt together frame structure that can be easily driven or flown by helicopter to a remote site and erected by two people.

The CP system is controlled by a CPC-300 cathodic protection controller, which is a small, low-cost 300 watt DC/DC converter.

The CPC-300 is a fully automatic controller that provides user adjustable control for the output based on maximum on-potential, voltage and current set-points. The controller's mode of operation is displayed via four super-bright LEDs, with the user adjustable set-point potentiometer adjacent to the corresponding LED. The controller also provides a microprocessor controlled user definable high and low shutdown voltage control so that the unit will shutdown automatically to protect the input supply battery from draining down too low.

Incoming DC power is filtered, isolated, rectified and filtered again to a controlled DC output. The input and output surge protection is provided by internal disk-style Metal Oxide Varistors (MOVs). The CPC-300 has a single 8 channel 3.5 digit LCD display to read set-points and actual values of voltage, current, on-potential, shut down set-point and input battery voltage.

  • DC output: 24v DC solar panels/wind generator
  • AGM (absorbed glass mat) battery bank
  • Potentiometer adjustment
  • Output voltage range: 0 to 24v DC
  • Output current range: 0 to 12.5 ADC
  • Metering: 2 percent tolerance, temperature compensated
  • Cooling by natural air convection
  • Operating ambient: -40° to +40°C (-40° to 104°F)
  • Limited options available on request
  • Advantages
  • No fossil fuels being utilized
  • Typically less expensive than a similar TEG setup
  • No piping required (as compared to a TEG)

cpc green rectifier

Corrpro U.S. Materials

11616 W 59th Street
Sand Springs, OK 74063

Ph: 918.245.8791
Fax: 918.245.8798


Corrpro Canada Materials & Corrpower Manufacturing

10848 – 214 Street N.W.
Edmonton, Alberta  T5S 2A7
Phone: 780.447.4565
Materials Inquiries: cpcaquotes@aegion.com